17
INSTALLATION
TROUBLESHOOTING
Problem
The shade will not set a new bottom limit or the limit will not save.
Solution
■
Raise the shade to the fully open position, the shade may touch the
hard stop.
■
Lower the shade to the fully lowered position, the shade may stall on bottom hard limit.
■
Retry adjusting the bottom limit by following “Resetting the Shade” on page 15.
Problem
An opaque fabric panel is wrinkled, creased, or is rippling.
Solution
Place a hair dryer 6" away from the shade and apply heat for 30 seconds to release the creases, wrinkles, or ripples
in the fabric.
Problem
Replace the batteries in the battery wand.
Solution
■
Squeeze the cap latch to release
the cap and remove the cap from the battery wand.
■
Install the batteries according to the instructions on the battery wand
label.
■
Press the cap on until it latches.
NOTE:
Kirsch
®
recommends AA alkaline batteries for use with our
battery-powered shadings. These will provide more than one year of
operation, depending on usage. Lithium and rechargeable batteries are not
recommended.
Problem
Rechargeable battery wand needs recharging.
Solution
There are two methods for charging the rechargeable battery wand — the dual charging station or the
single charger.
CAUTION:
Rechargeable battery wand can only be charged with Kirsch provided charging options — alternative
charging devices may result in permanent damage.
Removing the Rechargeable Battery Wand from the Mount
■
To safely remove the rechargeable battery wand from your shade, grasp the end of the battery wand that is
furthest away from the power socket.
CAUTION:
Grasp the wand firmly prior to removal.
■
Using the indentation on the end of the battery wand, use your index finger to pull the battery out of
the mount.
NOTE:
The mount should remain installed and plugged into the shade cable during this process. You will
simply remove the wand from the mount.
(Continued on next page)
Cap
Latch
Battery
Wand
Squeeze
