Kirkland Signature 2127649, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 35 / 43

BURNERS
Cleaning Method:
◼
Clean the exterior of the burner with a wire brush.
◼
Clear any clogged burner ports with a straightened paper
clip.
◼
Do not use a toothpick as it may break off and clog the
port.
◼
Check and clean burner/venturi tubes.
1. Remove grill grates and flame tamers.
2. Remove the screw and cotter pin that hold the burner in
place. Remove gas burner from the grill.
3. Use a flashlight to inspect into the burner through the
burner inlet to ensure there is no blockage. If any
obstruction is seen, use a metal coat hanger that has been
straightened to clear them.
4. After inspecting the inside of burner for blockage,
reassemble burner by sliding the middle tube of the gas
burner over the gas orifice.
5. Reattach gas burner using screw and cotter pin.
35
TOP SEAR BURNER
Cleaning Method:
1.
Light the top seal burner. See the “Using Your Top Sear
Burner” section.
2. Close the grill hood.
3. Leave the burner on high for approximately 30 minutes.
4. Turn knob to OFF and let cool completely.
5. Brush off ash particles from the top sear burner.
SIDE BURNER
Cleaning Method:
◼
Clean the exterior of the side burner with a wire brush.
CAST IRON COOKING GRID
Cleaning Method:
1. Allow the burner cool down completely.
2. Clean the cooking grid with a wire brush.
GREASE MANAGEMENT SYSTEM
IMPORTANT: The grease tray should only be removed when
grill is completely cool.
The grease tray collects grease and food particles that fall
through the grill. Clean often to avoid grease buildup.
Cleaning Method:
◼
Remove the grease tray from the grill and remove the heat
tent from the tray.
◼
Wipe excess grease with mild detergent and warm water
by using paper towels.
◼
Rinse and dry thoroughly.
◼
Replace heat tent to grease tray and insert the grease tray
to the grill.
KNOBS AND FLANGE AREA AROUND KNOBS
IMPORTANT: To avoid damage to knobs or flange area
around knobs, do not use steel wool, abrasive cleaners, or
oven cleaner.
Do not soak knobs.
Cleaning Method:
◼
Mild detergent, a soft cloth and warm water.
◼
Rinse and dry.
CONTROL PANEL GRAPHICS
IMPORTANT: To avoid damage to control panel graphics, do
not use steel wool, abrasive cleaners or oven cleaner.
Do not spray cleaner directly onto panel.
Cleaning Method:
◼
Clean around the burner labels gently; scrubbing may
remove printing.
◼
Mild detergent, soft cloth and warm water.
◼
Rinse and dry.