Kinoton FP 25 E PREMIERE, Руководство по эксплуатации

Страница: 69 / 121

FP 25 E
Operation
Issue: 06/2011
57
5 .2 .2 FP 25 E with Spool Rack (standard with 1 friction drive)
5 .2 .2 .1 Threading Overview
1. Put the full film reel onto the
rear friction shaft
2. Thread the film through the guide
rollers on the rear side extension
arm
3. Thread the film via the
rear guide
roller on
the
projector head
4. Thread the film through the f
ore
side guide rollers on
the
projector head
5. Thread the film through the
feed sprocket
6. Thread the film through film gate
7. Thread the film through the
reverse-scan sound device
8. Thread the film through the
bottom sprocket
9. Put the
empty film reel
on the
fore side take-up friction shaft
and wind up film (2 - 3 windings)
X NOTE
General threading through the film
gate, see chapter 5.2.1.2.
5 .2 .2 .2 Starting the Projection
• Switch on the power supply - main switch on the spool rack in position “I”.
• Pin up the full film spool onto the rear friction shaft (take-off friction) and an empty
spool on the fore side friction shaft (take-up friction).
• Fix both spools by tilting the locking bar.
• Thread the film corresponding to the threading instruction.
• Switch on the friction drive - rotary switch on position “I”.
• Adjust the rotary switch to the corresponding spool size
(600 m) or (1800
to 5000 m) and to the corresponding tension direction (left or right) which depends on
the spool rotation direction.
• The friction drive is activated as soon as the film is tightly positioned in front of the
film break sensor.
• Start the projector by pressing .