FP 25 E
Issue: 06/2011
40
3 .9 .3 Electronically Controlled Fore Side and Rear Side Friction Drives (option)
Both friction shafts are driven by controlled motors (arrows).
Two friction drives are necessary if the projector is equipped either
- with a reverse running unit for reverse running through the film gate
or
- with a rewind control for rewind operation - film is guided outside the
film gate.
X
NOTE
Z
Normally the set value is pre-adjusted and have not to change. Nevertheless, if
adjustments are necessary, they should be carried out by service engineer of
KINOTON (see projector’s service manual).
Z
Operating the frictions, see chapter 4.4.4.
ATTENTION
Never use reels which have an inner diameter less than ¼ of the reel diameter
because the film tension gets too large when the reel diameter approaches the inner
diameter.
3 .9 .4 Reel Shaft on an Interchangeable Flange
The reel shaft is mounted with a changeable
flange (for different sizes of film spools).
To fix a film spool/reel you have either to close
lock bar or screw on a knurled nut.
• To change the flange loosen the 3 Allen
screws (arrows) and change the flange.
Содержание FP 25 E PREMIERE
