Kingsom KS-200DH, Руководство по эксплуатации и обслуживанию

Страница: 26 / 31

2. Broken Soldering Iron Cord
There are two methods of
Testing the soldering iron cord
3. Replacing the fuse
2. Measure the resistance value
‘a’, ‘b’, and ‘c’ to confirm
that the leads are not twisted
and that the grounding wire is
properly connected.
3. To confirm that the clasp (9)
is clasped with heating elem-
ent(10).
1. Turn the unit ON and set the
temperature control knob to
highest. Then wiggle and kink
the iron cord at various locat-
ions along its length, including
in the strain relief area. If the
LED heater lamp flickers,
then
the cord needs to be replaced.
2. Check the resistance
between
the pin of the plug and the
wire on the terminal.
Pin1: Blue Pin2: Red
Pin3: Shielded Conductor
Pin4: White Pin5: Black
Pin6: Green. The value should
be 0. If it is greater than 0 or
is ∞, the cord should be rep-
laced.
1. Unplug the power cord from
the power receptacle.
2. Remove the broken fuse.
3. Remove the fuse holder.
4. Replace the fuse.
4.
Put the fuse holder back in
place.