25
LOGC50 Log Assembly
UNIT SHOWN.
STEP 1 -
Units are equipped with latches. To remove
glass door, unfasten latches and lift door off bottom
door retainer.
STEP 2 -
Remove logs from carton and inspect each
log.
STEP 7 -
Locate Log #4 locator tab in the back
right hand side of firebox. Butt Log #4 up to
locator tab. Position short Y branch onto ledge
(rear section) of Log #2. NOTE : Ensure at this
time that logs are not sitting directly on top of
open gas ports.
STEP 4 -
Locate left side Log #1 locator tab.
Place Log #1 onto locator tab by aligning
placement hole on the underside of Log #1 with
tab.
STEP 5 -
Locate right side Log #2 locator tab.
Place Log #2 onto locator tab by aligning
placement hole on the underside of Log #2
with tab.
STEP 6 -
Locate the log locator tabs for Log
#3. The notched area of Log #3 is to be posi-
tioned up against the two tabs and rests onto
Log #1 (as illustrated).
STEP 3 -
Place the five grate bars (packaged
with unit) into the grate bar slots.
LOG #1
LOG #5
LOG #6
LOG #7
LOG #2
LOG #3
LOG #4
5 GRATE BARS
ROCK
GLOWING EMBERS
LOCATOR TAB
LOG #4
LOCATOR TABS
LOG #3
LOCATOR TAB
LOG #1
LOCATOR TAB
LOG #2
GRATE BARS
