19
Brick Installation - For Models ZDV3318/ZDV3622
1.
Remove 3 mounting screws from air adjustment plate and remove plate.
On ZDV3318 or ZDV3622 the false bottom will have to be removed.
(Note: Air adjustment plate must be reinstalled in the same position in which it was removed.
2.
Remove top brick clip and screws from firebox side. Screws will be reused for the installation of side Liner Panels. (Fig. 1)
3.
Remove four side screws from the firebox bottom. There are two screws per side. Screws will be reused for the installation of side
Liner Panels. (Fig. 1)
4
Place rear Liner Panel against back of firebox. When placing Panel tilt panel towards you and lift panel over the burner assembly. (Fig. 2)
5.
To place side Liner Panels rotate panel towards you and place bottom edge of panel over the front ledge of firebox. (Fig. 3) Rotate
panel upright and slide back up to face of rear Liner Panel. Make sure top of side Liner Panel is engaged with top of rear Liner
Panel. (Fig 4 - Detail: A) To finish the installation fasten bottom of side Liner Panel with screws removed in step 3 and fasten top
of side Liner Panel with screws removed in step 2.
6.
Using screws removed in step 1 reinstall air adjustment plate and false bottom.
(Note: If air adjustment plate was required to be installed in the up position it is not required to reinstall the air adjustment plate.
Not installing the air adjustment plate will leave mor of the rear Liner Panel exposed for a more finished appearance.
