Kingsman MQVL60LP, Руководство по установке

Страница: 34 / 83

MQVLBG60 Front Glass Installation
To Remove Glass Front:
1. Remove the [Qty 4] Wing Nuts on
the Upper Glass Retainer and
remove the retainer.
2. Loosen the [Qty 4] Wing Nuts on the
Lower Glass Retainer but do not
remove. Glass Front can now be
lifted out of the fireplace.
To Install Glass Front:
1. Loosen Upper and Lower Side Glass
Retainer wing nuts until they are only
lightly snug (See A and B at right).
2. Place a bead of High Temp Silicone
on all four corners of the firebox
gasket (see above). This will seal
any gaps between where the gasket
and the glass corners meet.
3. Install Glass Front into the Lower
Glass Retainer. Install Upper Glass
Retainer. Tighten wing nuts until
lightly snug.
4. Match Glass Front up with Side
Glass at each end using Alignment
Tabs (See above).
5. Tighten wing nuts on Glass Front
until they are snug. Next, fully finger-
tighten wing nuts on Side Glass, and
then back them off 1/4 to 1/2 turn.
Finally, finish tightening all wing nuts
on Glass Front.
NOTE: Do not over tighten nuts as
glass could break.
Wingnuts should be finger-tight on
Glass Front.
⚠
IMPORTANT: Each corner must
have a dab of high-temp silicone
placed between the ball of the
gasket and the corner glass. This
will fully seal the firebox corners.
SILICONE
Front Glass is placed in front of
corner glass edge.
Upper Glass Retainer
X4
A: Upper Side Glass Retainer
B: Lower Side Glass Retainer
High Temp Silicone on
Firebox Gasket at corner
High Temp Silicone on
Firebox Gasket at corner
SILICONE
ALIGNMENT
TAB
34