Kingsman Marquis Infinite MQRB5143LP, Руководство по установке

Страница: 11 / 57

11
MQRB5143 Framing Your Gas Fireplace
This section is intended for qualified installers only. Before beginning, make note of where the gas and electrical accesses
are located on the unit. This will streamline the construction process. Furthermore, familiarize yourself with the venting and
clearance requirements (see Venting section) for this appliance. Failure to comply with those requirements can seriously
compromise the safety and operation of the fireplace.
Specifications
1. Cold climate installation recommendation: When installing this fireplace against non insulated
exterior wall or chase, it is recommended that the outer walls be insulated to conform to
applicable insulation codes. Drywall & vapor barrier must be installed over insulation to prevent
contact of insulation and unit.
2. Choose fireplace location and frame in accordance with the fireplace framing dimensions
specified (see framing diagrams).
3. Drywall or other combustible material can extend up to the Drywall Stops located on the sides
of the unit, and up to the bottom and top.
4. When installing horizontal with a 90 degree bend maintain a minimum of five inches [5"] above
the bend with the Wall Thimble Shield [Z57WTS] in enclosures below seventy-two inches [72”].
5. A Hearth is not required for this unit.
Certified for installation in a bedroom or bedsitting room. In Canada must be installed
with listed millivolt thermostat. In USA see local codes.
Stand-off Locations
Make note of where the stand-off locations are. These stand-offs are provided as indicators to illustrate
the boundaries for framing. Therefore, no framing material is permitted to extend beyond these stand-
offs.