15
INSTALLING - GLMVF38 Burner Systems and
LOGF38 Logs
Log Installation (Part # LOGF38)
The Kingsman log set has been numbered for ease of installation
1. Place log #1 onto plate with the ODS Pilot extending through the
notch area. Position holes on under side of Log #1 with the 2 vertical
tabs on the plate and lower onto the plate.
2. Place log #4 onto plate opposite of plate with the ODS Pilot.
3. Position Log #5 onto end Pin of Log #4 as shown in diagram.
4. Position Log #3 onto center Pin of Log #4 as shown in diagram.
5. Position Log #2 onto Pin of Log #1 and position Log #2 up against
Log #4.
NOTE: LOG #5 IS TO BE POSITIONED ON THE NON FLAME SIDE.
Crushed Rock Installation
Place crushed rock onto firebox bottom
making sure not to place any rock onto the
burner or burner ports, as this will cause
carboning, delayed ignition, and will raise
Carbon Monoxide to very dangerous lev-
els.
INSTALLING - Log Grate
ATTACHING LOG GRATE TO
FIREPLACE BASE
1. Position log grate into fireplace and mark screw loca-
tions on each side of mounting bracket.
2. Remove grate assembly, drill 2 holes at the marked
locations.
3. Attach grate assembly to fireplace base. (Screws not
provided.)
4. Connect to gas supply.
WARNING
You must secure this heater to fireplace base, or heater
will move when you adjust controls. Moving heater
may cause a gas leak and may result in property damage
or personal injury.
WARNING
Failure to position the parts in accordance with the dia-
grams or failure to use only parts specifically approved
with this heater may result in property damage
or
personal injury.
WARNING
The positioning of the logs is critical for the safe and clean operation of this heater. Sooting and other problems can
occur if the logs are not properly and firmly positioned in the heater. Never add additional logs or embellishments
such
as pine cones,vermiculite, volcanic rock or rock wool to the heater.
FIGURE 10 – Log Placement
Содержание GLMVF38MVN
Страница 2: ...2...
