Kingsman Fireplaces MQZCVBG34LPE2, Руководство по установке

Страница: 32 / 80

MQZCVBG34 -Glass Door Information-
Glass Cleaning
It will be necessary to clean the glass periodically. During startup, condensation, which is normal, forms on the inside of
the glass, and causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It is therefore recommended that initially the glass be
cleaned two or three times with a fireplace glass cleaner. After that, the glass should be cleaned two or three times a
season depending on the circumstances.
Glass Replacement - Firebox
Only
Robax ceramic or coated Neoceram glass may be used for replacement. Glass must be minimum 5mm thick. Be
sure to purchase glass from an authorized dealer.
To replace glass, remove old gasket and clean glass. Peel backing from
new gasket and install as shown below.
Use caution when working with glass. Wear gloves.
Suction Cups Recommended.
Removal of the Glass Front:
Refer to
Glass Door Front Removal /
Installation
section of this manual.
1. Remove nuts with a 3/8” wrench.
2. Remove Glass Door.
Removal of the Glass Side Doors:
Refer to
Glass Door Side Removal
section of this manual.
1. Remove nuts with a 3/8” wrench.
2. Remove Glass Door.
Glass Replacement – Safety Glass Barrier
Only
Tempered Low E Glass may be used, and coated side of glass must face
toward firebox.
Be sure to purchase glass from an authorized dealer.
Refer to
Glass Safety Barrier Installation / Removal
section of this manual.
Use caution when working with glass. Wear gloves.
Suction Cups Recommended.
⚠
Cautions and Warnings
•
Do not clean when the glass is hot.
•
The use of substitute glass will void all product warranties (see Glass Replacement in this section).
• Care must be taken to avoid breakage of the glass.
• Do not operate this fireplace without the glass front or with a broken glass front.
•
Do not strike or abuse the glass.
Round part of
gasket goes
toward firebox.
FIRE
BO
X
G
LAS
S
Suction Cups Recommended
32