PA G E 1 4 I N S T R U C T I O N M A N U A L
K D M 4 0 1 a
Setup IP
System
Setup IP
Following the main Submenu flow charts (pages 6 and 7) enter the ‘System Setup IP’ .
Press the
OK button
to enter the Submenu .
Enable DHCP:
DISABLE
Press the
OK button
to enter ‘Enable DHCP’ mode . Press the
OK button
to enter edit mode .
Press or arrows to Enable/Disable the DHCP . Press the
OK button
to save .
IP address:
192 .168 .1 .168
Netmask:
255 .255 .255 .0
Default Gateway:
192 .168 .1 .3
Press the
OK button
to access IP adjustment mode . Set the first number of the IP address/
Netmask/Default Gateway using the or arrows, then use the arrow to advance to the
next digit . Press the
OK button
to save (0-999) .
NOTE:
Repeat above steps for Netmask and Default Gateway .
Reset System
System
Reset System
Following the main Submenu flow charts (pages 6 and 7) enter the ‘System Reset System’
mode . Press the
OK button
to enter the Submenu .
Reset Mode
Hard/Soft Reset
Press the
OK button
to enter ‘Reset Mode’ . Use the or arrows to select between either
Hard or Soft Reset . Press the
OK button
to enter the next page .
Reset Mode
Reset to Default
Press the
OK button
to enter ‘Reset to Default’ . There will be a confirmation on the display .
Press or arrows to select YES or NO . Select ‘
y’
for yes, the system will be reset to default .
Select ‘
n’
for no to cancel . Press the
OK button
to confirm .
Upgrade Code
System
Upgrade Code
Following the main Submenu flow charts (pages 6 and 7) enter the ‘System Reset System’
mode . Press the
OK button
to perform the upgrade .
Process Command
Please wait . . .
Once upgrade is complete, press the
OK button
to reboot .
RETRIEVE STREAM STATUS
Following the main Submenu flow charts (pages 6 and 7) enter the ‘Advanced Menu System’ . In ‘Retrieve Status’ mode .
Press
OK button
to check the parameters of your previous settings in ‘Stream’ .
SYSTEM
Advanced Menu
System
Following the main Submenu flow charts (pages 6 and 7) enter the ‘Advanced Menu System’ .
Press the
OK button
to enter the Submenu .
System
Rtrv Inventory
Press the
OK button
to enter the next page, press the
OK button
again to check both
hardware and software versions .
Are you sure?
y
When the ‘Stream Set TS ID’ has been set, there will be a confirmation on the display .
Press or arrows to select YES or NO . Select ‘
y’
for yes, all the settings above will be
stored in the memory . Select ‘
n’
for no to cancel . Press the
OK button
to confirm .