PA G E 1 0 I N S T R U C T I O N M A N U A L
K D M 4 0 1 a
Aspect Ratio
Video
Aspect Ratio
Following the main submenu flow charts (pages 6 and 7) enter the ‘Aspect Ratio’ mode .
Press the
OK button
to enter the Submenu .
VIDEO
Video
Set Video
Following the main Submenu flow charts (pages 6 and 7) enter the ‘Set Video’ mode .
Press the
OK button
to enter the Submenu .
Port Number:
1
Press the
OK button
to access port number adjustment mode . Use the or arrows to select
the port number, press the
OK button
to save .
Encoder Rate:
6M
Press the
OK button
to enter encoder the adjustment mode . Use the or arrows to set the
Encoder rate, press the
OK button
to save .
Are you sure?
y
When the ‘Set Video’ has been set, there will be a confirmation on the display .
Press or arrows to select YES or NO . Select ‘
y’
for yes, all the settings above will be
stored in the memory . Select ‘
n’
for no to cancel . Press the
OK button
to confirm .
Tune Color
Video
Tune Color
Following the main submenu flow charts (pages 6 and 7) enter the ‘Video Tune Color’ mode .
Press the
OK button
to enter the Submenu .
Port Number:
1
PRESS
the
OK button
to access port number adjustment mode . Use the or arrows to
select the port number, press the
OK button
to save .
NOTE:
Use the same steps in Tune Color for ports 2-4 .
Cont:
20
Press the
OK button
to enter the adjustment mode . Use the or arrows to set the first
digit, use arrow to select the second digit, use the or arrows to set . Press the
OK
button
to save . (0-50) .
Brightness: 21
Hue: 25
Saturation: 35
Sharpness: 14
Use the same steps as above to set – Bright (0-50) .
Use the same steps as above to set – Hue (0-50) .
Use the same steps as above to set – Saturation (0-50) .
Use the same steps as above to set – Sharpness (0-50) .
Are you sure?
y
When the ‘Tune Color’ has been set, there will be a confirmation on the display . Press or
arrows to select YES or NO . Select ‘
y’
for yes, all the settings above will be stored in the memory .
Select ‘
n’
for no to cancel . Press the
OK button
to confirm .
Are you sure?
y
When the ‘Modulator’ number has been set, there will be a confirmation on the display . Press
or arrows to select YES or NO . Select ‘
y
’ for yes, all the settings above will be stored in the
memory . Select ‘
n
’ for no to cancel . Press the
OK button
to confirm .
RETRIEVE RF OUTPUT STATUS
Following the main Submenu flow charts (pages 6 and 7) enter the ‘Retrieve Status’ mode, you can check the parameters
of your previous settings in ‘Setup RF Output’ .