Revision 7 Date: 22 Jun 2020 Page 8 of 13
Use [▲, ▼] to change value of selected digit and [▼] to change the sign
(positive or negative) of a set value.
Set the 3 displayed thresholds types (see below) with the desired values:
ALARM (displayed as “
!
”)
PASS (displayed as “
√
”)
FAIL (displayed as “ x
”)
Press [OK] to save settings.
Note that if an invalid threshold value was entered, it
will exit from Threshold Editing Mode & return to Home Display without saving.
Use [►] to select the next wavelength and set the respective thresholds by
repeating steps in 3.6.4.
3.6.5
Press [OFF] to exit Threshold Editing Mode and return to Home Display.
The Threshold Management Display or Threshold Editing Mode will exit
automatically if no subsequent key is pressed 10 sec after being selected.
3.7 Measurement with Pass/Fail Display Mode
At Home Display, press and hold [▲] to enter Threshold Management
Display, see picture below.
The pass/fail/alarm
sign
displayed beside
each measurement
reading to show their
respective test result.
Selected threshold group
