ASSEMBLY and INSTALLATION continued...
5
Deck mount installation
16.
Mark the center of the area you
would like the Kingfisher Canopy to
cover.
17.
Measure 250mm each side of
this mark. This is the centre of the
deck mounts (part D).
18.
Decide whether the canopy will fold
down to the front or the back (check
it will lay flat in your chosen position
-
alter as necessary).
19.
Make sure the mounts are posi-
tioned at the correct width
(Kingfisher Canopy frame will flex 50
inwards
-
100mm outwards if need-
ed).
20.
Place the deck mount (part D) in po-
sition and mark holes for drilling.
Drill the holes through the gunwale
using a 5.5mm bit.
21.
Place the deck mounts in position
and bolt them down (using parts A, B
& C). N.B. Take care not to strip Phil-
lips head in bolt A, and lubricate bolt
A to avoid binding bolt to nut.
22.
Now you can fit the Eclipse Canopy
to the deck mounts. The Kingfisher
logo on the canopy should be at the
back of the boat.
23.
Before opening canopy apply some
silicone spray/wipes to the legs and
make sure that the fabric is covering
the corners of the end bows.
Figure 21
Mounting hardware bag
D
A
B
C
D
CENTER
(of the area that the canopy is to cover)
250mm
250mm
(from the center of the deck
mount)
Figure 22
Canopy Position
