ASSEMBLY and INSTALLATION continued...
3
8.
Take the 4 bent end bow sides (Part N°4 &
5) and place them in pairs with the plastic
insert
Figure 7
facing downwards. Now
screw on the bow knuckles making sure
that the nut recesses are facing outwards.
Figure 8
9.
Screw the end bow sides (Part N°4 & 5) to
the 4 stays and sliding knuckles using the 4
cam leaver assemblies.
Figure 9.
Make sure
that the two stainless tube ends (Part N° 5)
are connected to main bow side.
Figure
10.
10.
Lay the two halves of the “A” frame on the
ground/work bench and layout the fabric
top as shown in
Figure 11. NOTE: The top is
inside out with the brand facing the
ground.
Make sure that the two Main bow
legs are facing upwards.
11.
Take the two end bow joiners (Part N° 6)
and slide them through end pockets of the
fabric top, leaving the holes on each end
exposed.
Figure 12
Figure 7
Plastic Insert
Figure 8
End Bow Knuckles
Figure 10
Complete End
Stainless Tube End
Main Bow Side
Figure 11
Bimini Laid Out
Main Bow Sides
(Part N°1) Facing
upwards
Figure 12
End Bow Joiners in Top
Figure 9
Cam Leaver
