King-Dome 9762-LP, Инструкция по установке и эксплуатации

Страница: 13 / 44

1. Mount the dome unit. Use the pre-drilled holes in the mounting feet as a guide to install
the fasteners into the roof. Use additional fasteners whenever necessary.
2. Test that the dome unit is secure by pulling upward from each foot location.
3. Fill end of coaxial cable that will connect to the MAIN port on the dome unit with supplied
grease (Fig. 11) .
4. Connect coaxial cable to the MAIN port and tighten connection.
If using a second receiver, fill end of second coaxial cable and connect it to the port
labeled AUX. Tighten connection.
DO NOT OVER TIGHTEN CONNECTIONS.
Page 11
Note. The King-Dome is wired for a dual LNB. There are two coaxial ports on the back of the dome unit. The
one labeled “MAIN” MUST be connected to the Tuner (IDB) in vehicle. The one labeled “AUX” can be used
for an additional receiver (see page 15).
There are three lengths of coaxial cable supplied. The 7’ is used to connect the tuner to the receiver. The
longer two are for connecting the dome unit to the receivers. Use the shorter of the two for the closest
receiver, and the longer one for the receiver farthest away.
IMPORTANT! You must fill the ends of the external coaxial cables with the supplied dielectric grease.
Fig. 11
IMPORTANT!
You must fill the ends of the
external coaxial cables with the
supplied dielectric grease.
Coax connections
should be snug.
DO NOT OVER TIGHTEN!