King-Dome 9762-LP, Инструкция по установке и эксплуатации

Страница: 27 / 44

Page 25
5. On the receiver remote, press MENU 6 1 1.
6. Highlight Check Switch and press select.
7. Make sure Superdish and Alternate boxes
are NOT selected.
8. Highlight Test and press Select .
The unit will perform a check switch test, and the dish will periodically move back and
forth. (This process will take several minutes.)
9. When test is complete, SW21 appears as the
installed device, and there must be no “X”s
in the indicated columns.
If indicated results are not obtained, go back to Step 5 and run test again. Contact the
King Controls Service Department if the check switch fails to load after 4 attempts.
10. Save the settings, exit to the main menu screen and wait for your programming to
download.
MUST SHOW “SW21”
NO “X”s
Screen graphics may vary.