King-Dome 9762-LP, Инструкция по установке и эксплуатации

Страница: 11 / 44

Page 9
COMPONENT LOCATION
1. Determine the location of the internal components using the following criteria:
a) The Controller, Tuner, and Power Supply should be in the same general vicinity of
the main satellite receiver, and ACCESSIBLE FOR OPERATION AND
MAINTENANCE PURPOSES .
b) The Tuner should not be stacked directly on top of other electronics. If located in a
cabinet or other enclosure, make sure there is adequate ventilation around the unit.
c) The Controller should be conveniently located for the end user. (If using the Wall
Mount Faceplate, see page 16.)
d) All components should be secured so they do not shift or bounce around during
vehicle motion.
2. Place the components in the selected areas.
ELECTRICAL HAZARD WARNING!
The coaxial cable that connects the dome unit to the tuner carries a 24 volt electrical
current. Exercise extreme caution when handling this cable. Do not cut, break, or splice
this line. Do not insert or connect any devices such as splitters or any other device for any
reason. This line is not compatible with any other equipment. Damage will occur to any
device other than the dome unit if connected to the antenna port on the tuner.
To verify proper operation of the components in their selected locations, perform a System
Location Check as follows:
1. TEMPORARILY connect system as shown on pages 14 and 15 .
2. Verify system operates properly as described in Section 4 OPERATION, Page 18 .
3. After verifying system operates properly, disconnect all components.
SYSTEM LOCATION CHECK