King-Dome 9754-LP, Инструкция по установке и эксплуатации

Страница: 28 / 40

1. Turn on the TV and satellite receiver.
2. On the King-Dome controller, press and hold the
ON/SEARCH button for 3 FULL SECONDS .
The antenna will lock onto the appropriate satellites
before completing the search process.
After the satellites have been located and the acquisition process is complete,
the status light will be steady green.
3. On the receiver remote, press menu, 6, 1, 1.
4. Highlight Check Switch and press select.
5. Make sure Superdish and Alternate boxes
are NOT selected.
6. Highlight Test and press Select.
The unit will perform a check switch test, and the dish will periodically move back and
forth. (This process will take several minutes.)
Page 26
IMPORTANT! YOU MUST HAVE COMPLETED THE ANTENNA CONFIGURATION (STEP 2-A, PAGE 16 OR
STEP 2-B, PAGE 23) BEFORE RUNNING THE CHECK SWITCH.
For automatic satellite switching, King Controls recommends using a Dish Network model
311 receiver for Dish 500, and a Dish Network model VIP211 or a VIP211k HDTV receiver for
Dish HD/HD Eastern Arc/HD Alternate. Do not use dual tuner receivers or recorders.
If you do not have a clear view of the satellites, the switch will not load.
Note: The SW21 and SW64 switches are a receiver software configuration that is loaded into the receiver after
running a check switch test with the dish locked on and configured for the appropriate service.
This one time procedure will not need to be repeated after successful installation, unless a) check switch
test is run again while connected to a home dish system, b) check switch is run when a receiver is not
connected, or c) you travel outside the coverage area of the pre-set satellite trio and switch trios (Dish
HD/HD Eastern Arc).
STEP 3: DISH AND EXPRESSVU CHECK SWITCH PROCEDURE
Screen graphics may vary.