Kinetic
®
digitizor
TM
M-DAB 0001 User Guide
18
USE IN AUTOSCAN MODE
digitizor will automatically switch on and commence transmitting each time you turn on
the car ignition.
Turn on your in-car audio system and go to the FM band.
Ensure your car radio's display is set to show FM station names.
If your car radio has AF, TP and/or TA functions please set all to 'off'.
Tune your car radio and store digitizor's four default FM frequencies (87.6MHz, 92.5MHz,
102.5MHz and 107.9MHz) on four convenient preset buttons.
Tune the car radio to 87.6Mhz.
1. Press MENU followed by
◄◄
or
►►
until the display shows [FM MODE].
2. Press
■
followed by
◄◄
or
►►
until the display shows [AUTOSCAN].
3. Press
■
.
AutoScan mode is now permanently enabled (until you either deliberately switch back to
AFC mode or carry out full reset of digitizor.)
Select DAB stations according to the instructions on page 20.
To listen to FM/AM stations switch digitizor to standby by pressing the
q
button once.
To return to DAB press
q
again and retune your car radio to digitizor's transmission
frequency.
CUSTOMISING THE FM TRANSMITTER FOR BEST PERFORMANCE IN
AUTOSCAN MODE
As you travel around, digitizor automatically and continuously scans the FM band for
three clear frequencies in the locality and stores them on the FM button.
If you experience interference from an FM radio station, change digitizor's transmission
frequency:
1. Press and hold the FM button, then retune your car radio to the new frequency that
is shown on the display.
or
2. Press the FM button repeatedly to select one of the three clear frequencies [SX
frequency
], followed by
■
, then retune your car radio to the new frequency that is
shown on its display.
or
3. Change to one of the four default FM transmission frequencies by pressing the FM
button, then either button number 1 (87.6MHz), 2, (92.5MHz), 3 (102.5MHz) or 4,
(107.9MHz) followed by
■
, then select the appropriate FM radio preset.
Depending on your car radio, it may be necessary to press
■
to return the display to
