32
Elevation 1+
© 2011 Kinesys Projects Ltd
15
Replacing an Elevation
If an installed Elevation 1+ needs to be replaced, the following settings should be
copied from the original Elevation 1+ to the new unit. They are shown below in a table
to help locate them in the menu structure.
Setup
Limits
Upper
Data
Max Upper Travel
Lower
Data
Max Lower Travel
Comms
Address
Data
Comms Address
Data
Position
Data
Current Position
It is a good idea to note down these settings down for all the Elevation 1+ controllers in
an installation so you are prepared if one needs to be replaced.
The one parameter that you will not be able to record in preparation is the current
position. This should be entered into the replacement Elevation 1+ if the hoist being
controlled is at a known position or its position can be estimated from the position of
other hoists in the system.
The following parameters are normally the same for all Elevation 1+ controllers
connected to the same type of motor within an installation. Their values should be
checked on the replacement controller.
