POWER PAK II / PLUS II
6
1. Charging the POWER PAK II Battery (Cont.)
a. 240V AC Charger (10) - Once fully charged the 240V AC Charger (10) can be left connected to the POWER PAK II as the
charger will perform a maintenance charge.
Caution: It is recommended that the 240V AC Charger (10) be turned OFF within 48 hours after charging has completed to
save electricity.
b. 12V DC Car Charger (11) - It is not recommended to leave the POWER PAK II connected to your vehicles 12V output
source for extended periods of time as this could potentially drain your vehicles battery.
Caution: If the POWER PAK II jump starter will not turn ON, the current overload or low voltage protection may have activated.
To reset the jump starter you must connect the supplied 240V AC Charger (10) to your mains power, then connect the
charger lead to the 15V DC 1A Input Charging Port (6) & turn ON the mains power. This will reset the POWER PAK II
jump starter and should now function as normal.
POWER PAK II Operation
2. POWER PAK II Pre-Operation Check
Caution: Before using the POWER PAK II ensure your vehicle battery has a CCA rating of 400CCA or less for KP1405 & 600CCA
or less for KP1406.
Trying to start any vehicle with a battery rated greater than 400CCA for KP1405 & 600CCA for KP1406 could trip the
current overload protection or cause damage to the POWER PAK II and void the product warranty.
Caution: Refer to your vehicles instruction manual for “connection of jumper cables” as some vehicles have specific
connection requirements.
3. Follow the below instructions when your vehicle will not start due to a low voltage, flat, damaged or low
temperature battery.
4. Ensure the Battery Charge LED Indicators (2) are illuminated, a minimum of 3 BLUE LED’s are illuminated before trying
to jumpstart your vehicle.
5. Do not attempt to jumpstart your vehicle if the Battery Charge LED Indicators (2) are illuminated with less than
3 BLUE LED’s.
6. If the Battery Charge LED Indicators (2) are showing 2 or less illuminated BLUE LED’s; recharge the POWER PAK II as
specified in “Charging the POWER PAK II Battery” on Pages 5 & 6.
7. Do not touch or connect the Positive Battery Clamp RED (12) to the Negative Battery Clamp BLACK (13)
at any stage. Connecting the Battery Clamps (12 & 13) together may lead to damage of the POWER PAK II, and/or
vehicles battery and could be dangerous.
8. Always ensure you connect the jump starter clamps to the correct battery terminals, connect the Positive Battery
Clamp RED (12) to the positive terminal (+ RED) of your vehicles battery and the Negative Battery Clamp BLACK (13) to
the negative terminal (- BLACK) of your vehicles battery otherwise you may cause damage to the POWER PAK II
or your vehicle.
9. Always check that the Battery Clamps (12 & 13) have a good connection to the vehicle battery terminals.
10. Check that the vehicle battery terminals are free of corrosion and are clean, to ensure a positive connection of the
POWER PAK II.
11. Do not try to restart the vehicle after 3 consecutive starting attempts, otherwise you may cause damage to the
POWER PAK II. Check your vehicle for other possible reasons prior to trying to start your vehicle again.
