POWER PAK II / PLUS II
5
POWER PAK II Care and Charging
Important Notice
1. If the 240V AC Charger (10) supplied is damaged, it must be replaced by the manufacturer or an authorised Kincrome
service agent or similarly qualified persons in order to avoid a hazard.
2. When installing or removing the charger connector plugs, please hold the connectors firmly.
3. Don’t stretch the wire or damage can occur to the wire & plugs.
Note: For optimal performance, charge the POWER PAK II every 3-6 months and keep the POWER PAK II stored in a cool dry
environment to extend the life of your product.
1. Charging the POWER PAK II Battery
Note: Charge the POWER PAK II whenever the Battery Charge LED Indicators (2) are illuminated with 2 or less bars.
It is also recommended to charge the POWER PAK II periodically (approx. every 3-6 months) to keep the POWER PAK II
in optimal operating condition.
To check the batteries level of charge, press the ON/OFF/TEST Button (1) and refer to the below chart to confirm level of
charge of the POWER PAK II.
Battery
Charge
Indicator (2)
Unlit
LED’s
4 Flashing
LED’s
1
Illuminated
LED
2
Illuminated
LED’s
3
Illuminated
LED’s
4
Illuminated
LED’s
Battery
Charge
Condition
0%
10%
25%
50%
75%
100%
A. Charging with the 240V AC Charger
a. To charge the POWER PAK II with the 240V AC Charger (10) locate the charger plug/
adaptor on the end of the charging cable of the 240V AC Charger (10) and insert into the
POWER PAK II 15V DC 1A input Charging Port (6) (fig1).
b. Plug the 240V AC Charger (10) into your wall socket and turn ON the mains power. When
the POWER PAK II is charging the Battery Charge LED Indicators (2) will flash ON & OFF
until each level of charge has been reached and will illuminate continuously.
When finished charging, all Battery Charge LED Indicators (2) will turn OFF.
B. Charging with the 12V DC Car Charger
a. To charge the POWER PAK II with the 12V DC Car Charger (11) locate the 12V charger
lead/adaptor on the end of the 12V DC Car Charger (11) charging cable & plug into the
POWER PAK II 15V DC 1A Input Charging Port (6) (fig 2).
b. Plug the 12V DC Car Charger (11) into your 12V DC vehicle accessory socket located
within your vehicle (refer to your vehicles instruction manual for the location
of your 12V DC accessory sockets). When the POWER PAK II is is charging
the Battery Charge LED Indicators (2) will flash ON & OFF until each level of
charge has been reached and will illuminate continuously.
When finished charging, all Battery Charge LED Indicators (2) will turn OFF.
(fig 1)
(fig 2)
