Kilews KTM-1000, Инструкция по эксплуатации

Страница: 31 / 31

KTM-1000
30
Troubleshooting Guide
Problem Possible Cause Solution
Inconsistent torque readings
Wrong filter set Adjust peak time filter
Rundown joint not being used
Always use a rundown joint when
testing power tools
Tool is not being held consistently
Ensure that driver is held securely
and in the same plane for every
rundown
Torque tester is not properly
secured Ensure that tester base is
anchored securely
Tool being tested is unable to
hold consistent torque value
Send tool in for evaluation
Torque tester needs calibration
Send torque tester in for
calibration
Unit turns off by itself
Low battery Recharge the unit
Sleep mode time set too short Adjust sleep mode time
Unit will not turn on
Low battery Recharge the unit
Flash memory error Perform hard reset
Calibration of Unit
Periodic calibrations are required in order to maintain a high standard of accuracy. In most applications a
6-12 month calibration interval is acceptable. Please contact your local distributor or the manufacturer
when your unit is due for calibration.
Performing a Hard Reset
A hard reset can be performed by pressing the button located inside the hole on the back of the
torque tester while the unit is unplugged. After the reset button has been pressed, the unit will not turn
on until it is plugged in again. The calibration state and profiles will remain unchanged, but this
operation will reset the clock and all other settings to their default values.