Kikusui PWX750ML, Руководство пользователя

Страница: 76 / 110

76
PWX
Series Operation
You can connect up to two units in series. You cannot perform master-slave series operation.
The total of the output voltages of the two units is applied to the load. The voltage setting
accuracy is the same as the accuracy of an individual unit.
Features of the PWX750ML during series operation
The features of the PWX750ML during series operation are as follows:
Voltage display and current display
The voltage and current are displayed on unit 1 and unit 2. To calculate the total output volt-
age, add the voltages of unit 1 and unit 2.
p.24
You can switch the display so that it shows power. The power is displayed on unit 1 and unit
2.
External control
Chapter
This is available.
External monitoring
p.67
• External monitoring of the output voltage (V MON)
You can monitor the output voltage of each unit.
To calculate the total output voltage, add the monitor values of the master unit and the
slave unit.
• External monitoring of the output current (I MON)
This can only be monitored from the master unit.
• Status monitors
You can monitor the status of the following items from the master unit and from the slave
unit: constant-voltage mode (CV STATUS), constant-current mode (CC STATUS), output
on, POWER switch on, and alarms.
See
Lit
Lit
Unit 1
Unit 2
Example of the panel display
during series operation
(The output current is 28 A.)
See
WARNING
During monitoring, be careful of shorts and electric shocks. When monitoring the out-
put voltage or output current during master-slave series operation, the electric poten-
tial of the commons of the master unit’s monitor signal and the slave unit’s monitor
signal are different.
See