Kidde Fire Protection ANTARES, Руководство пользователя

Страница: 66 / 91

TM0064 Page 66 of 91 Issue 2.01
3.4.6 Program Loop Outputs
Having assigned output numbers to the necessary output devices the inputs that when
activated operate them can now be programmed. This is achieved with the Program Loop
Outputs option. The display for this option when selected is shown in fig 3.4.12.
TUE 15 MAR 21:45 PROGRAM LOOP OUTPUTS
OUTPUT ? L D ?
Fig 3.4.12
The output number requested is that which was assigned to the output device using the previous
option. The number is entered and accepted in the normal manner. The clear status for the
output was programmed in the previous option so the panel will immediately request entry of a
loop number. The loop number is that on which the input devices, which will activate the output,
are located.
When the loop number is accepted the active status for each device for that loop is displayed and
modified as in the Program Panel Outputs option.
The active status is indicated by an O or A. As for the Program Panel Outputs option the active
status is toggled using the numeric keys whilst the ENTER/YES and CANCEL/NO keys
increment and decrement the device number respectively.
TUE 15 MAR 21:45 PROGRAM LOOP OUTPUTS
PUT 2 L 02 D 013 A
Fig 3.4.13
The option will time out if no keys are operated but can be terminated using the
CANCEL/NO key the appropriate number of times.
3.4.7 Load/Save Program (Psion only)
The SAVE option allows for all site program data to be downloaded from the panel onto the
Psion and then saved in DATAPACKS as required. The Load option allows these files to be
reloaded into the panel in the event of any data corruption. Selection of this option transfers
full control to the Psion, the panel display indicating as shown below.
TUE 15 MAR 21:45 LOAD/SAVE PROGRAM
REFER TO REMOTE COMPUTER
Fig 3.4.14