EMA -88
ENGINE MECHANICAL SYSTEM
OIL AND FILTER
E5D0D7D0
CAUTION
•
Prolonged and repeated contact with mineral
oil will result in the removal of natural fats
from the skin, leading to dryness, irritation
and dermatitis. In addition, used engine oil
contains potentially harmful contaminants
which may cause skin cancer.
•
Exercise caution in order to minimize the
length and frequency of contact of your skin
to used oil.
Wear protective clothing and
gloves. Wash your skin thoroughly with soap
and water, or use water-less hand cleaner,
to remove any used engine oil. Do not use
gasoline, thinners, or solvents.
•
In order to preserve the environment, used oil
and used oil filter must be disposed of only at
designated disposal sites.
1.
Park the car on level ground.
Start the engine and let it warm up.
2.
Turn the engine off and open the hood.
Remove the engine cover.
3.
Wait for 5minutes after loosening the oil filter cap by
turning it counterclockwise with SST(09263-3C100)
to drain well the oil in the oil filter.
09263-3C100
ECRF051A
4.
Drain the engine oil.
a.
Remove the oil filler cap.
b.
After lifting the car, remove the oil drain plug and
drain the oil into a container.
5.
Replace oil filter.
a.
Disconnect the oil filter cap from oil filter body.
b.
Remove the oil filter element.
c.
Check and clean the oil filter installation surface.
d.
Check the part number of the new oil filter is as
same as old one.
e.
Install new oil filter element(A) and two new
O-rings(B).
B
A
KDRF188A
f.
Apply clean engine oil to the new O-rings.
Lightly screw the oil filter cap into place, and
tighten it until the O-ring contacts the seat.
g.
Finally tighten it again by specified tightening
torque.
Tightening torque
24.50Nm (2.5kgf.m, 18.08lb-ft)
CAUTION
When replacing a oil filter, the water temperature
control(WTC) assembly should not be stained
with oil.
6.
Refill with engine oil.
a.
Install the oil drain plug with a new gasket.
Tightening torque
34.3 ~ 44.1Nm (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)
b.
Fill with fresh engine oil, after remove the engine
oil level gauge.
Capacity
Oil filter : 0.4L(0.42U.S.qus, 0.35lmp.qts)
Drain and refill : 5.2L(5.49U.S.qus, 4.58lmp.qts)
c.
Install the oil filler cap and oil level gauge.
7.
Start the engine and check to be sure no oil is leaking
from the drain plug or oil filter.
8.
Recheck engine oil level.
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir
