7
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Pirouette Tables™ Nesting-Base with Villa, PowerUp or No Power - Modesty Panel
Assembly Instructions
modesty
panel
Figure 11
Detail K
wire
manager
#10 x / ”
3
4
screw
clip
#10 x / ”
3
4
screw
weld
bump
mounting
hole
clip
pivot
rod
Modesty Panels Installation
Note:
18” to 24” deep tables may
have modesty panels installed to
them, but 30”-36” deep tables do not
allow that option.
1. With table upside down on a soft,
protective surface, position the
modesty panel down near the back
edge of the tabletop where it will
install. The wire manager on the
modesty panel should face up, and
the notches exposing the pivot rod in
the panel should face the back edge
of the table as illustrated (Figure 11).
2. Locate the mounting clips and
position them over the weld bump on
the pivot rod as illustrated. The tabs
with the mounting holes must face
the modesty panel, or disassembly
and reassembly will be required
(Figure 11 & Detail K).
3. Move the modesty panel with clips
up to align the mounting holes of
the clips with the pre-drilled holes
in the table. The mounting holes will
be close to the edge near the wire
trough mounting holes. Screw each
clamp to the underside of the table
with a #10 x
3
/
4
” wood screw per
clamp as illustrated (Figure 11 &
Detail K).
Note:
Pirouette Tables less than 72”
in length will use two clamps per
modesty panel, but 72” long tables
will use three clamps to the tabletop.
