10
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Pirouette Tables™ Nesting-Base with Villa, PowerUp or No Power - 18” Table-to-Table Ganging
Assembly Instructions
CAUTION:
If Channels (Wire Troughs)
are used they are not to be used for routing
extension cords. Power supply cords are
not to be routed across or through more
than one complete unit/tabletop.
WARNING:
Assembly of all table
components must be completed before
making any electrical connections. All
electrically connected furnishings must
also be mechanically connected.
Table-to-Table Ganging, 18”
Pirouette Nesting-Base Tables
Note:
Take note of correct ganging
hook and peg mounting locations to
assure proper latching for
table-to-table installation. The
instructions on this page describe
hook and peg installation for ganging
of 18” deep tables, table-to-table. For
24”, 30” & 36” deep tables, see
page 8 instructions.
1. Carefully turn table to the upright
position. As illustrated, position the
two ganging hooks as shown, at the
underside of the first table. Install the
two hooks to the first table using two
pegs and #14 x 1
1
/
2
” wood screws.
Next, install four pegs at the other
illustrated locations on the first table
for future use to store ganging hooks
(Figure 15).
2. At the second table, install two pegs
inline with the first set of pegs with
installed ganging hooks and four
pegs for future use to store ganging
hooks (Figure 15).
3. Move tables together and swing the
ganging hooks of the first table to
securely engage the pegs under the
second table (Figure 15 & 16).
Figure 15 - 18” Nesting-Base Tables with Table-to-Table Ganging
Figure 16 - 18” Nesting-Base Tables with Table-to-Table Ganging
ganging hook
(engaged)
ganging hook
(engaged)
pegs
(for storage)