5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Pirouette Tables™ Nesting-Base with Villa, PowerUp or No Power - PowerUp Module
Assembly Instructions
tabletop
tabletop
cutout
Figure 8
PowerUp module
with 3-prong plug
snap
tabletop
cutout
snap
PowerUp module
with 3-prong plug
Detail F
Pirouette Table with PowerUp
Module
Note:
If tables are configured
table-to-table or back-to-back, tables
must be mechanically connected with
gangers or splice plates.
1. With the assembled table in the
upright position, orient the PowerUp
module as shown and route the
3-prong plug end down through the
grommet hole cutout in the tabletop.
Press the module down firmly into
the cutout to secure in place, making
sure the front and rear snaps catch
under the cutout bottom edge of the
tabletop (Figure 8 & Detail F).
2. To open the PowerUp module, push
down lightly on the lid dimple and
release. To close module, push
lid down until slightly recessed in
module body and release. Open and
close the module to ensure smooth
operation (Details G & H).
3. Select the appropriate data plate
adapter for the phone/data jack to
be used and carefully remove from
injection molded tree (Detail I).
Note:
Jacks are sold by separate
companies and are not supplied with
the module.
4. Wire the jack appropriately to the
data plate and snap the data plate
assembly into the module grommet
opening as shown (Detail J).
Note:
Depending on style of data
jack used, it may be necessary to
route the phone/data cord through
the module grommet opening and
data plate to install. Each installation
may vary.
5. The PowerUp module may be
removed without tools by squeezing
the front and rear snaps located on
the module under the tabletop while
pushing up the module (Figure 8).
Detail G
Detail H
A
B
C
D
E
Data Adapter Plates
Detail I
Blank Plate
Panduit “CJ”
Othonics “Trackjack”
AT&T
Panduit “KJ and KJA”, Amp CAT-3
and CAT-5, Hubble “Hd5”,
Ortronics “OR-6295003-T568B”
and “OR-6295004-T568A”
Krone, Leviton “41108-RE5”
A
B
C
D
E
Detail J
