6
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Pirouette Tables™ Nesting-Base with Villa, PowerUp or No Power - Vertical Wire Manager & Wire Trough
Assembly Instructions
Wire Trough Installation
Note:
The wire trough is an optional
accessory and must be specifically
ordered.
1. If the PowerUp or Villa power module
was installed, make sure the cover
is closed, then carefully rotate the
table to be upside down on a soft,
protective surface.
2. If wire trough is provided, position
the wire trough over the underside
of the power module as illustrated,
with the two smaller rectangular RPT
mounting holes facing the back edge
of the table. Route the power cord
out of the end of the trough. Align the
wire trough mounting holes with the
pre-drilled holes in the underside of
the tabletop, and secure wire trough
to tabletop using six #14 x
3
/
4
”
self-tapping screws. Do not
over-tighten (Figure 10).
3. Strap in the module cord using
the installed Velcro
®
wire manager
(Figure 10).
Vertical Wire Manager
Installation
1. If the PowerUp or Villa power module
was installed, make sure the cover
is closed, then carefully rotate the
table to be upside down on a soft,
protective surface.
2. Strap in the module cord using
the installed Velcro
®
wire manager
(Figure 9).
3. To install vertical wire manager, route
the power cord along the leg, then
snap the wire manager to the post
with the cord in between. Vertical
wire manager easily snaps on and off
the leg, to add or reconfigure cords
(Figure 9).
Figure 10
#14- /
3
4
self-tapping
screw
wire
trough
tabletop
Velcro
®
wire manager
power module
with 3-prong plug
(PowerUp shown)
Figure 9
tabletop
power
cord
vertical
wire manager
Velcro
®
wire manager
power module
with 3-prong plug
(PowerUp shown)
