KI Genesis Desking, Руководство по сборке

Страница: 9 / 16

Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
9
Genesis
®
Desking - Overhead Stanchions
Assembly Instructions
Note: The overhead stanchion
attaches to the underside of the
worksurface. There are two methods
to attach the overhead stanchions
(step 3A or 3B).
3A. Attach each stanchion fully
assembled using six #14 x 1”
Phillips head screws (Figure 18).
3B. Remove the two #14 x 1
1
/
2
” Phillips
head screws and attachment plate
from the stanchion (Figure 19),
then attach the plate to the
worksuface using six #14 x 1”
Phillips head screws (Figure 20).
This allows the legs to be installed
to the worksurface without the
stanchions (see below). Stanchions
can be attached later to the
attachment plate using the two
#14 x 1
1
/
2
” Phillips head screws
(Figure 21).
4. Install the left- and right-hand
grommet trim pieces to the cutout
in the worksurface (Detail I).
Legs Installation
1. Attach the legs to the underside of
the worksurface using six #12 x 1”
Phillips head screws per leg
(Figure 22 & Detail J).
worksurface
underside
post
leg
standard
leg
standard
leg
#12 x 1”
Phillips head
screw
Figure 22
Detail J
stanchion
attachment
plate
#14 x 1 / ”
Phillips head
screw
1
2
Figure 19
Figure 18
stanchion
tabletop
attachment
plate
#14 x 1”
Phillips head
screw
attachment
plate
#14 x 1”
Phillips head
screw
Figure 20
stanchion
#14 x 1 / ”
Phillips head
screw
1
2
Figure 21
Detail I
tabletop
underside
grommet
trim
piece