KI Genesis Desking, Руководство по сборке

Страница: 10 / 16

10
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Genesis
®
Desking - Overhead
Assembly Instructions
Overhead Installation
Note: If task lights are to be
installed, install them to the overhead
before installing overhead to
stanchions.
1. The hardware pack contains four
#8-32 x
1
/
2
” Phillips locking pan
head screws. Only two of these will
be used in the overhead installation.
The other two mounting screws
must be removed from the overhead
prior to setting the overhead on the
stanchions (Figure 23).
2. Set the overhead onto the stanchions
so the back of the overhead is fairly
flush with the back of the stanchion
plates. Align the attachment holes
on the overhead with the two angle
bracket holes (Figure 23).
3. Attach the overhead to the angle
bracket at the top of each stanchion
using four #8-32 x
1
/
2
” Phillips
locking pan head screws (two from
the hardware pack and two removed
from the stanchion)(Figure 23).
4. If a Universal Overhead is to be
installed, using a #10 x 1” Phillips
self-tapping screw and flat washer,
secure the overhead to each
stanchion bracket. If a Balance
Overhead is to be installed, using
a
5
/
16
-18 x
3
/
4
” Phillips pan head
screw, secure the overhead to each
stanchion bracket.
Note: The Balance
®
clam shell
style overhead uses an additional
5
/
16
-18 x
3
/
4
” Phillips pan head screw
for mounting (one per stanchion)
(Figure 24).
#8-32 x / ”
Phillips pan
head screw
1
2
#8-32 x / ”
Phillips pan head screw
(from hardware pack)
1
2
stanchion
stanchion angle
bracket
overhead
Remove this screw
from the overhead
and reassemble through
the rear slotted hole in
the stanchion angle
bracket
Figure 23
#8-32 x / ”
Phillips pan
head screw
1
2
right-hand
stanchion
left-hand
stanchion
flat
washer
Figure 24
#10 x 1” Phillips
self-tapping screw
(used on Universal
overheads only)
5 3
/ -18 x / ”
Phillips pan head screw
(used on Balance Clam
Shell overheads only)
16 4