Enlite Tables
Assembly Instructions
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
7
Power/Data Module
(PowerUp
®
) continued
4. To open module, push down
lightly on the lid dimple and
release. To close module,
push lid down until slightly
recessed in module body and
release (Figure 13).
5. Select the appropriate data
plate for the phone/data
jack to be used (see chart)
and carefully remove from
injection-molded tree (Figure
14). Jacks are sold by
separate companies and not
supplied with the module.
6. Depending on style of jack,
it may be necessary to route
phone/data cord through
module grommet opening
and data plate to install. Wire
jack appropriately and snap
into data plate. Snap data
plate assembly into module
grommet opening as shown
(Figure 15).
7. The PowerUp module may
be removed without tools
by squeezing the front and
rear snaps located under the
worksurface while pulling up
on a module (Figure 15).
Data Plate
Letter
Opening Size
Phone/Data Jack
A
None
Blank
B
.635 x .730
Blank
C
.670 x 9.29
Panduit “CJ”
D
.585 x .780
Panduit “KJ” and “KJA”, amp CAT-3 and CAT-5,
Hubbel “HD5”, Otronics “OR-6295003-T568B”
and “OR-6295004-T568A”, Krone, Leviton
“41108-RE5”
E
.680 x .710
ATT & T
Содержание Enlite ENBT AD Series
Страница 1: ...Assembly Instructions Enlite Tables March 2017...
Страница 2: ......
Страница 11: ...Enlite Tables Assembly Instructions 9...