Getting Started
1
Keysight X8712A IoT Device Battery Life Optimization Solution User’s Guide
33
Settings
Description
Trigger
Set triggering point to start or
stop tabulating the results.
Two trigger modes available.
Single Mode
Send immediate trigger to the
measurement system.
Settings for Single Mode
– Status: To trigger instrument remotely with/without reset.
– Reset: Reset the N6705C default settings and data according to
software settings. The software will reset the settings for Power
supply and may turn OFF/ON the channel. You will see the
changes at front panel.
– Without Reset: Keep existing instrument settings. The software
will promote the message check box when the hardware and
software configuration settings are different. The software will
take control of the settings.
– Delay: Select the check box to enable delay time between pressing
the Acquire button and the actual start time of the measurement.
– Delay(s): Enter the desired delay time in seconds. Default: 0.
– Center Frequency (MHz): Range from 100 to 2900 MHz.
Default: 2402 MHz.
Triggered Mode
Only start capturing waveform
when criteria are met.
Triggered Mode will enable the following additional settings:
– Source: The software will save the last trigger settings across all 4
channels. Select 1 channel at a time.
– Slope:
– Rising: Increasing waveform.
– Falling: Decreasing waveform.
Level: Set the threshold level (shown in green below).
– Time Variable (s): Set the time out.
– Time Out (s): Product of Time Variable and Time Span.
– Offset: Defines the offset in a data sweep when the measurement is
triggered. Value should less than half of the entire time span.
Default: 0.01 seconds.
