Keysight M9005A PXIe Chassis User Guide
17
Getting Started With The System
Installation and Configuration
Connecting Safety Ground
Connecting to Power Source
Attach input power through the rear AC inlet using the appropriate AC power
cable supplied. Refer to
on page 5, to locate the AC inlet.
The power switch allows you to power on the chassis or place it in standby
mode. Press the power switch to turn on the chassis. Observe that the fan
becomes operational.
Getting Started With The System
To set up and use your cards, you need the following:
-
One host card (PCI Express or ExpressCard) and one M9005A chassis
-
A x1 copper cable
-
A host PC with an available x1 (or wider) PCI Express slot or a laptop with an
available ExpressCard slot
When rack-mounting, leave a 1 U air gap above and below the
chassis.
You may want to remove the feet from the chassis when rack
mounting. To do so, remove the screws holding the feet in place.
The M9005A chassis is designed with a three-position inlet that
connects the cord set ground line to the chassis ground.
To minimize shock hazard, make sure the electrical power outlet
you use to power the chassis has an appropriate earth safety
ground.
-
Do
not
install modules prior to performing the following
power-on test.
-
To completely remove power, you
must
disconnect the power
cable.
Содержание M9005A
