Keysight M8920A, Руководство по началу работы

Страница: 41 / 93

Step 4 -Install the Modules
M8920A Getting Started Guide 41
5. Before inserting the module into the chassis, back the mounting screws out to
ensure that there is no interference between the screws and the mounting
rails.
6. See M8920A Instrument Connections (page 43) for positioning the M8920A
modules.
7. Holding the module by the injector/ejector handle, slide it into an available
PXIe (or hybrid) slot, as shown in the following figure.
a. Install the module into the slot of the chassis by placing the module card
edges into the front module guides (top and bottom).
b. Slide the module to the rear of the chassis and ensure that the
injector/ejector handle is pushed down in the unlatched (downward)
position.
c. Slide the module completely into the chassis. When you begin to feel
resistance, pull up on the injector/ejector handle to fully inject the
module into the chassis.
8. Secure all modules to the chassis using the module mounting screws. Use a #1
Pozidriv or a slotted screwdriver and torque to 5 in-lb (0.57 Nm). Performance
may suffer if the screws are not tightened properly.
9. Verify that the PXIe chassis fans are operable and free of dust and other
contaminants that may restrict airflow.
10. Install filler panels and slot blockers after installing the modules. Missing filler
panels or slot blockers may disrupt air circulation in the chassis. The left-most
slot does not accept a slot blocker.