Keysight 33210A, Руководство пользователя

Страница: 69 / 351

67
Chapter 3 Features and Functions
Output Configuration
3
• For frequency sweeps with Marker Off, the Sync signal is a square
waveform with a 50% duty cycle for the duration of the sweep. The
Sync signal is a TTL “high” at the beginning of the sweep and goes
“low” at the midpoint of the sweep. The Sync signal is synchronized
with the sweep, but is not literally equal to the sweep time because its
timing includes the re-arm time.
• For frequency sweeps with Marker On, the Sync signal is a TTL “high”
at the beginning of the sweep and goes “low” at the marker frequency.
• For a triggered burst, the Sync signal is a TTL “high” when the burst
begins. The Sync signal is a TTL “low” at the end of the specified
number of cycles (may not be the zero-crossing point if the waveform
has an associated start phase). For an infinite count burst, the Sync
signal is the same as for a continuous waveform.
• For an externally-gated burst, the Sync signal follows the external
gate signal. However, note that the signal will not go to a TTL “low”
until the end of the last cycle (may not be the zero-crossing point if
the waveform has an associated start phase).
• Front-Panel Operation: Press and select the
Sync
softkey again
to toggle between “off” and “on”.
• Remote Interface Operation:
OUTPut:SYNC {OFF|ON}
Setting is stored in non-volatile memory
33210A users guide.book Page 67 Wednesday, July 16, 2008 11:16 AM