1
Keysight ZA0060A Quick Start Guide
46
Bluetooth
®
5 UUID Read Write Tests
This test plan has similar test steps with
Bluetooth
®
LE Signaling test plan and is
only applicable for DUT that supports Connect Request PER. See the table below
for description of the additional test steps.
Test Step and Description
The ‘Initialize BLE Radio’ and ‘BLE Device Discovery’ test steps and settings are as described in
Establish Connection
Sets the DL power and establishes connection with a DUT that supports Connect Request. See the
settings for DL Power in
and the description of System Offset in
5 Advertising Channel Power Measurement
.
Read UUID by handle
Reads the UUID handle (decimal or hexadecimal) of the characteristic set of your DUT. Select the
‘Custom’ option in the drop-down list to enter a custom handle value. Ensure that the VISA address of
the 34999B RF module is selected.
Write UUID
This test step writes the UUID of the characteristic set in
into the DUT.
The Data Byte list can accept a list of bytes in decimal or hexadecimal formats. Each byte should be
separated by a comma. Examples, Decimal list: 1,2,3 and Hex list: 0x01,0x02, 0x03 would both result in
the same data being written. Note that the data should match the structure of the specific characteristic
that is being written. This will be very DUT dependent and the user will need to understand the operation
of the DUT.
Read UUID by characteristic values
Select the desired characteristic values for the test step to read the UUID of the supported
characteristics as shown below.
