Keysight U3810 Series Getting Started Guide
69
3
Next connect a wire from the
*5 pin
of
J9
to the
G
of the
TRI-COLOR LED
.
4
Connect a wire from the
*6 pin
of
J9
to the
B
of the
TRI-COLOR LED
.
The diagram above might appear dark in print outs. Refer to
for the searchable PDF to help you locate the locations of the jumpers,
connectors and components.
5
Run the program and observe the different colors on the TRI-COLOR LED. Note this program has
a special exit routine to reset the PWM pins back to the default mode.
./RGB_LED_PWM
NOTE
If the file does not exist, enter the command below to compile the code.
gcc M1_L1_RGB_LED_PWM.c -l mraa -o RGB_LED_PWM
6
Press
Ctrl + C
to exit the program and disconnect all jumper wires.
Содержание U3810A
Страница 1: ...Keysight U3810A Advanced IoT Teaching Solution Getting Started Guide ...
Страница 78: ...Keysight U3810 Series Getting Started Guide 78 IMU Characteristics from the LSM9DS1 datasheet ...
Страница 131: ...Keysight U3810 Series Getting Started Guide 131 ...
Страница 132: ...Keysight U3810 Series Getting Started Guide 132 Disassembly ...
