Keysight M9451A PXIe Measurement Accelerator
18
1.
2.
3.
Power up the Controller
If you are using a remote controller and you have installed the interface
cable, you must power up the chassis
you power up the PC. When
BEFORE
you power down your chassis, Shut Down the PC
you power down
BEFORE
the chassis.
PXIe hardware does not support "hot-swap" (changing modules while
power is applied to the chassis) capabilities. Before installing or removing a
module to/from the chassis, power off the chassis to prevent damage to the
module.
If you are using an embedded controller, complete the following steps:
Install the embedded controller module into the compatible chassis. The
Keysight M9036A PXIe Embedded Controller and Keysight M9018A PXIe
Chassis are recommended. Please refer to the embedded controller and
chassis documentation for further details.
Connect peripherals (mouse, keyboard, monitor).
Power up the chassis.
Software Installation Overview
This installation includes the following:
Keysight IO Libraries Suite (IOLS), which includes the Keysight Connection
Expert. This software is available at
software must be installed first.
Version 16.3.16603.3 (or newer) of the Keysight IO Libraries Suite is
required.
Instrument software, which includes the soft front panel (SFP), device
drivers (IVI-C and IVI-COM) and documentation for Keysight M9451A PXIe
Measurement Accelerator. This software is included with your shipment and
is also available at
.
