Keyline NINJA LASER, Руководство по эксплуатации и обслуживанию

Страница: 34 / 172

E
N
GLISH
6 Keyline S.p.A. NINJA LASER Man. cod. B409927FG Copyright by Keyline - Italy
TRANSPORT AND INSTALLATION
3Transport and installation
3.1.0 Packaging
Packaging includes a cardboard box with the following dimensions:
IMPORTANT!

We recommend you to keep the packaging during the
warranty period.
3.2.0 Transport
The markings on the packing materials indicate how to handle the
machine during transport.
3.2.1 Unloading and handling the machine
The machine can be unloaded manually by 2 or 3 persons, or by using
a handling equipment (for example a lift truck).
Avoid dropping the machine, even a small damage
could impair its correct functioning.
3.3.0 Temporary storing
If the installation of the machine does not occur immediately, store
the machine in a dry and properly ventilated place.
• Apply an appropriate coating.
• Rubber parts must be protected against too low tempera-
tures. Never store them outdoors, not even for short peri-
ods.
If the machine is stored or remains unused for long pe-
riods or if it is started a long time after delivery, gaskets
or retaining rings may undergo hardening thus causing
leaks or seizures.
3.3.1 Characteristics of the place of installation
The key cutting machine must be placed on a smooth level bench
about 90 - 110 cm (35 - 43 Inches) high, suitable for bearing the weight
of the machine and keep it horizontal, thus avoiding vibrations and
stress.
Allow a 30 cm (12 Inches) clearance around and above the key cutting
machine for correct functioning and maintenance.
3.3.2 Temperature and humidity
The tool should be used in rooms with a temperature range of 0 and 40
°C (32.0° - 104.0° F) and a relative humidity lower than 50 - 60%.
3.3.3 Working environment
The machine must be used in a place protected from bad weather
(rain, hail, snow etc.).
If the machine is used in places exposed to corrosion,
maintenance shall be scheduled in such a way as to
prevent extreme wear of the components.
Do not use the machine in explosive or partially explo-
sive atmospheres or in the presence of inflammable
liquids of gases.
3.3.4 Lighting
In the place of installation lighting must be appropriate, in order to al-
low the correct use and maintenance of the machine.
3.4.0 Connections
3.4.1 Grounding
Key cutting machines NINJA LASER have been designed in compli-
ance with the safety legislation in force and feature appropriate safe-
ty devices to prevent work accidents. In particular the machine was
built with materials that:
• are self-extinguishing;
• protect against electrocution.
The machine must be grounded through the centralized circuit of the
place of installation.
Warning:
Make sure that the main voltage is compatible with the
machine voltage.
Make sure that the active power outlets are grounded.
Do not touch the machine when your hands and/or feet
are wet or humid.
Avoid any contact with grounded plates.
Dimensions Machine
Width 440 mm
Height 500 mm
Depth (Length) 540 mm