3
EN
1 - SAFETY WARNINGS
ORIGINAL INSTRUCTIONS - important safety
instructions. Follow the instructions since in-
correct installation can lead to severe inqui-
ry! Save these instructions.
Read the instructions carefully before proceeding
with installation.
The design and manufacture of the devices
making up the product and the information in
this manual are compliant with current safe-
ty standards. However, incorrect installation
or programming may cause serious injury to
those working on or using the system. Com-
pliance with the instructions provided here
when installing the product is therefore extre-
mely important.
If in any doubt regarding installation, do not pro
-
ceed and contact the Key Automation Technical
Service for clarifications.
Under European legislation, an automatic
door or gate system must comply with the
standards envisaged in the Directive 2006/42/
EC (Machinery Directive) and in particular
standards EN 12445; EN 12453; EN 12635 and
EN 13241-1, which enable declaration of pre-
sumed conformity of the automation system.
Therefore, final connection of the automation
system to the electrical mains, system testing,
commissioning and routine maintenance must
be performed by skilled, qualified personnel, in
observance of the instructions in the “Testing and
commissioning the automation system” section.
The aforesaid personnel are also responsible for
the tests required to verify the solutions adopted
according to the risks present, and for ensuring
observance of all legal provisions, standards and
regulations, with particular reference to all requi-
rements of the EN 12445 standard which establi-
shes the test methods for testing door and gate
automation systems.
Before starting installation, perform the fol-
lowing checks and assessments:
ensure that every device used to set up the au
-
tomation system is suited to the intended system
overall. For this purpose, pay special attention
to the data provided in the “Technical specifica-
tions” section. Do not proceed with installation if
any one of these devices is not suitable for its
intended purpose;
check that the devices purchased are sufficient to
guarantee system safety and functionality;
perform a risk assessment, including a list of the
essential safety requirements as envisaged in An
-
nex I of the Machinery Directive, specifying the so
-
lutions adopted. The risk assessment is one of the
documents included in the automation system’s
technical file. This must be compiled by a profes-
sional installer.
Considering the risk situations that may arise du-
ring installation phases and use of the product,
the automation system must be installed in com-
pliance with the following safety precautions:
never make modifications to any part of the auto-
mation system other than those specified in this
manual. Operations of this type can only lead to
malfunctions. The manufacturer declines all liabi
-
lity for damage caused by unauthorised modifica-
tions to products;
do not allow parts of the automation system to be
immersed in water or other liquids.
if the power cable is damaged, it must be repla-
ced by the manufacturer or its after-sales servi-
ce, or in all cases by a person with similar qualifi-
cations, to prevent all risks;
During installation ensure that no liquids are able
to enter the various devices; should this occur,
disconnect the power supply immediately and
contact a Key Automation Service Centre. Use of
the automation system in these conditions may
cause hazards;
never place automation system components
near to sources of heat or expose them to naked
lights. This may damage system components
and cause malfunctions, fire or hazards;
The drive shall be disconnected from its power
source during cleaning, maintenance and when
replacing parts. If the disconnect device is not in
a visible location, affix a notice stating: “MAINTE
-
NANCE IN PROGRESS”:
connect all devices to an electric power line
equipped with an earthing system;
the product cannot be considered to provide ef
-
fective protection against intrusion. If effective
protection is required, the automation system
must be combined with other devices;
ATTENTION !
ATTENTION !
ATTENTION !
