Kettler KB142-ZXRW, Перевод оригинальной инструкции по эксплуатации

Страница: 63 / 154

MY21K01 - 32_1.0_24.09.2020
63
Operation
3 Detach high-pressure damper pump.
4 Measure the distance between the crown and
the dust seal. This distance is
total deflection of
the fork.
5 Push a temporarily attached cable tie
downward against the dust seal.
6 Put on your normal cycling clothing, including
luggage.
7 Sit on the pedelec in your usual riding position
and support yourself against an object, such as
a wall or tree.
8 Get off the pedelec without allowing it to
deflect.
9 Measure distance between the dust seal and
the cable tie.

This measurement is the sag. The
recommended value is between 15% (hard)
and 30% (soft) of the total fork deflection.
10 Increase or reduce air pressure until you have
reached the desired sag.
11 If the sag is correct, turn the air valve cap
clockwise.
12 If you are unable to achieve the required sag,
an internal adjustment may be needed.
Contact your specialist dealer.
6.5.6.3 Setting the Suntour rear frame damper
Only applies to pedelecs with this equipment

When adjusting the sag, ensure that the
compression adjuster is in an open position, i.e.
the
lockout lever is in the OPEN position.
1 Remove the valve cap from the air valve .
Attach a high-pressure damper pump. Adjust
the rear frame damper air pressure to the
rider's weight. Detach high-pressure damper
pump.
2 Measure the distance between the air chamber
seal and the end of the rear frame damper.
This gap is the
total rear frame damper
deflection .
3 Put on your normal cycling clothing, including
luggage. Sit on the pedelec in your usual riding
position and support yourself against an
object, such as a wall or tree.
4 Push the O-ring downwards against the air
chamber seal.
5 Get off the pedelec without the suspension fork
deflecting.
 Measure the distance between the air chamber
seal and the O-ring. This measurement is the
sag. The recommended value is between 25%
(hard) and 30% (soft) of the
total rear frame
damper deflection .
6 Increase or reduce the air pressure until you
have reached the desired sag.
 If the sag is correct, fasten the valve cap onto
the valve.
Notice
If the air pressure in the rear frame damper is
exceeded or undershot, the damper can be
permanently damaged.
Do not exceed the maximum air pressure of
300 psi (20 bar).