Kettler KB142-ZXRW, Перевод оригинальной инструкции по эксплуатации

Страница: 59 / 154

MY21K01 - 32_1.0_24.09.2020
59
Operation
6.5.5 Retracting the brake linings
Disc brakes require wearing-in time. The braking
force increases over time. You therefore need to be
aware that the braking force may increase during the
wearing-in period. The same happens after brake
pads or discs are replaced.
1 Accelerate pedelec to about 25 km/h.
2 Brake pedelec until it comes to a halt.
3 Repeat process 30–50 times.
The disc brake is retracted and provides optimal
braking power.
6.5.5.1 Setting the grip distance on a
Magura HS33 brake lever
Only applies to pedelecs with this equipment
You can adjust the brake lever position (grip
distance) to your requirements. Such adjustment
does not affect the pressure point or the position
of the brake linings.

Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
Figure 72: Setting the grip distance on a Magura HS33
brake lever

Turn the setting screw anti-clockwise towards
minus (–).

The brake lever moves closer to the handlebar
grip.

Turn the setting screw clockwise towards
plus (+).
 The brake lever moves away from the
handlebar grip.
6.5.5.2 Setting the grip distance on a
Magura HS22 brake lever
Only applies to pedelecs with this equipment
You can adjust the brake lever position (grip
distance) to your requirements.

Use a T25 TORX® wrench to turn the setting
screw (1) to adjust the grip distance.
Figure 73: Setting the grip distance on a Magura HS22
brake lever

Push the brake lever gently and hold.
 Move the slider (2) outwards (–) to Position II
or III.
 The brake handle moves closer to the
handlebars.
 The brake linings move closer to the rim.
 The pressure point activates sooner.
 Move the slider inwards (+) to Position II or I.

The brake lever moves away from the
handlebars.

The brake linings move away from the rim.

The pressure point activates later.
1
2
Crash caused by incorrectly set grip distance
If brake cylinders are set or installed incorrectly,
braking power may be lost completely at any time.
This may cause a crash with serious injuries.
 Once the grip distance has been set, check the
position of the brake cylinder. Correct if
necessary.
WARNING
!