Kettler KB142-ZXRW, Перевод оригинальной инструкции по эксплуатации

Страница: 48 / 154

MY21K01 - 32_1.0_23.09.2020
48
Assembly
2 Push in the quick release until you can hear a
click. Make sure that the flange is extended.
Figure 58: Pushing the quick release in
3 Adjust tensioning with half-open clamping
lever until the flange reaches the fork end.
Figure 59: Adjusting the clamping
4 Fully close the quick release. Check that the
quick release is firmly in place and adjust it on
the flange if necessary.
 The lever is secured.
Figure 60: Closing the quick release
5.4.2 Installing the wheel in the FOX fork
5.4.2.1 Quick release (15 mm)
Only applies to FOX forks with 15 mm screw-on axle
The same procedure is used for installing both the
15 x 100 mm and 15 x 110 mm quick releases.
1 Place the front wheel in the fork ends of the
fork. Push the axle through the fork end on the
non-drive side and hub.
Figure 61: Pushing the quick release in
2 Open the axle lever.
3 Turn the axle five to six complete revolutions
clockwise into the axle nut.
4 Close the quick release lever. The lever must
be tensioned to the point that it leaves a mark
on your hand.
5 The lever must be 1 to 20 mm in front of the
fork leg in the closed position.
Figure 62: Spacing between lever and fork leg
 The quick release must be adjusted if the
lever is tensioned inadequately or too strongly
when closed in the recommended position
(1 to 20 mm in front of the fork).
1-20 mm