Kessler-Ellis Products INTELLECT-69PM2, Инструкция по установке и эксплуатации

Страница: 20 / 22

16
RS 422: When connecting the unit to a computer
with RS 422, five connections are needed. These
connections are: Receive data A (+), Receive data
B (-), Transmit data A (+), Transmit data B (-) and
Ground. The connections should be made as
follows:
DB-9 CONNECTOR COMPUTER
Trans. data A(+) (pin 2) Rec. data A(+)
Trans. data B(-) (pin 7) Rec. data B(-)
Rec. data A(+) (pin 3) Trans. data A(+)
Rec. data B(-) (pin 8) Trans. data B(-)
Ground (pin 5) Ground
TRANSMIT A (+) PIN (2)
GROUND PIN (5)
TRANSMIT B (-)PIN (7)
STROBE PIN (6)
RS 422
PRINTER BUSY PIN (1)
TRANSMIT A(+)PIN (2)
TRANSMIT B(-) PIN (7)
RECEIVE B(-)PIN (8)
RECEIVE A(+)PIN (3)
GROUND PIN (5)
RS 422
RS232 / RS422 WIRING
COMPUTER HOOKUP:
RS 232: When connecting the unit to a computer
with RS 232 communication, only three connec-
tions are needed. These connections are: Receive
data, Transmit data and Ground. The connections
should be made as follows:
DB-9 CONNECTOR COMPUTER
Transmit data (pin 2) Receive data
Receive data (pin 3) Transmit data
Ground (pin 5) Ground
PRINTER HOOKUP:
When connecting the unit to a printer, you must first
program the desired baud rate, parity and strobe list with
a computer. After the unit is
programmed it can be
connected to the printer. Connect the transmit
line(s) of the unit to the receive line(s) of the printer
and be sure that both devices have common
grounds. When the strobe line is triggered the unit
will transmit the selected strobe list which you had
previously programmed.
TRANSMIT PIN (2)
GROUND PIN (5)
RECEIVE PIN (3)
RS 232
1- Printer busy: 3 to 30 VDC level inhibits transmission.
2- Transmit A(+) (RS422); Transmit (RS232)
3- Receive A(+) (RS422); Receive (RS232)
4- Not Used
5- Ground
6- Strobe: 3 to 30 VDC positive edge starts transmossion.
7- Transmit B(-) (RS422 Only)
8- Receive B(-) (RS422 Only)
9- Not Used
DB - 9 CONNECTOR
1 2 3 4 5
6 7 8 9
RS 232
TRANSMIT PIN (2)
GROUND PIN (5)
STROBE PIN (6)
PRINTER BUSY PIN (1)