5 / 20
2018/08
434-033
Insert the SIM card into the SIM card holder provided and then insert the SIM card holder back into the modem.
Use to two screws to attach the modem back
onto the mounting plate, and connect the
power pack with the modem and the voltage
supply.
➀
➁
➂
➀
➁
Installation sheet for KESSEL TeleControl modem
Scope of supply
- TeleControl modem housing
- Modem (installed in housing)
- Mains plug
- Drilling template
- Attachment set comprising four screws including wall plugs
Not included in the scope of supply but necessary for function:
- SIM card from a network provider for remote data transfer
First steps before installation and commissioning:
Information about wireless
connection:
The strength of radio signals decreases as the distance to the transmitter increases.The
overall range is limited. Different factors of influence can deaden radio waves, e.g. wall
thickness and material, room geometry and volume, type and attachment of the receiver.
The characteristics of the radio signal must be checked and compared before installation.
KESSEL AG cannot accept liability for failures or fluctuations in the mobile network.
1. Insert the SIM card
For this purpose, loosen the control unit from the mounting plate using a Torx screwdriver
TX10 before starting installation.
The SIM card holder (right-hand side of the modem) can be released from the device by
pressing the yellow ejection opening. This can be done using a ballpoint pen or paper clip
for example.