25
Wartung / Maintenance
Cleaning recommendations for powder-coated surfaces
For optimal care and cleaning of powder-coated surfaces the following recommendations should
be followed:
- Use only a so& cloth or industrial cotton wool. Refrain from rubbing hard.
- Surface and cleaning agent temperature <25°C (do not steam clean surface).
- Clean slight staining with clear water (cold or lukewarm), small amounts of neutral or alkale
scent detergent additives may be used, if necessary.
- Stubborn staining, such as greasy or oily substances, may require the use of benzene hydrocar
bons which are free of aromatic compounds (test previously in a hidden surface).
- Do not apply detergent for extended periods of time. If necessary repeat cleaning process a&er
24 hours. Rinse well with cold, clean water immediately a&er cleaning.
- Do not use scratching, abrasive agents.
- Do not use acidic or strongly alkaline detergents and surfactants.
- Do not use organic solvents which contain ester, ketone, alcohols, aromatic compounds, glycol
ether, halogenated hydrocarbons or similar substances.
6
Wartung /
Maintenance
Sachbeschädigung durch Schmieren der Säulen
Durch Reinigung oder Schmierung der Rollenführung zwischen den Rohren
kann diese beschädigt werden.
f
Rollenführung nicht schmieren
f
Rollenführung nicht mit Lösungsmittel reinigen.
f
Keine silikonhaltigen Mittel verwenden, diese führen zum Quietschen der
Säule.
Material damage caused by lubricating the columns
Cleaning or lubricating the roller bearing between the tubes can damage it.
f
Do not lubricate the roller bearing.
f
Do not clean the roller bearing with solvent.
f
Do not use silicone-based products, as these will cause the mono column
to squeak.
Das Säulengestell benötigt keine Wartung
The column frame does not require any maintenance
Содержание Lift TM Q71
Страница 1: ...Montageanleitung Li gestell TM Q71 500 Original Version 2 0 09 2021 Cover Variante...
Страница 15: ...15 Montage Assembly 6 b3 6 b4 M8x18 7x SW 5 AF 5 10 Nm Sondermutter M8 1x...
Страница 23: ...23 Montage Assembly Tisch wieder umdrehen Arbeitsposition Flip table again working position 19 20...